Innovation by DX

As If You Were in That Space

You can feel your layout subjectively, which is created by Device Layouter on a Web browser and imported directly through Internet, using 3D stereoscopic display.

It's basically difficult to feel actual distances on Web browser. A Head Mounted Display allows you to confirm if distances between devices are sufficient or not, and so on, navigating in your 3D environment.

Instant Collaboration of Layout

You can share your result once you finalize your data creation.

Virtual Reality Viewer can be started from a Web browser.

It's possible to feel your layout with 3D stereoscopic display anywhere, whereever you create the data.

Time and Cost Reduction for Data Creation

It always takes considerable time and money to create a data for Virtual Reality.

Virtual Reality Viewer allows you to integrate your own data easily and feel your layout instantly.

Naturally, it's also possible to utilize a layout with pre-registered geometries.

Door Opening / Closing Animation Supported

When you navigate to a location which is close to a door, the door opens automatically. Once you go away from the door, the door closes automatically.

You can look into a room from outside. A setting to deactivate automatic door operation is available.

Any motion created in a CG software can be imported for an animation, through FBX format. You may use this feature for any other purpose than door opening and closing.

Intuitive Operations with Hands

VR controllers are supported. You can feel your VR environment as if you were placing equipment using your hands.

Virtual hands are shown at the current hand locations, and buttons on VR controllers can be detected. You can grip, release, or move devices. It will help your intuitive operations for your available space validation.

When each hand collides with a device, the system notifies it by the controller's vibration and the red highlight of the device. And then, you can grip and move it.

Measurement Feature

You can measure a distance between two points. Specify location in your 3D environment using a VR controller. Distances along axes are also displayed, as well as the actual length.